Made Noise – Sketch 6 – peaks and nulls

When I turned on my Make Noise synth tonight, I had anticipated some more experimentation with filter wobble. I had both QMMG and QPAS right in front of me, and so far in my brief experimentation, these two filters had been the best at it. And I did do some of that. It was the first thing I did for about 30 minutes. But, as it so often does, the patch sent me in a different direction. It’s still a delicate patch, but not in that kind of way.

This patch won’t get the full patch breakdown, but I’ll lay out the basic framework.

René X Channel > Spectraphon B (stereo outputs) > QPAS (Smile Pass 😁) > X-Pan
Spectraphon B (Sub) > QMMG Ch 2 (LPG) > QMMG Ch 1 (VCA) > X-Pan
The recording starts out with only the QPAS outputs, before bringing in the LPD’d version. Both are crossfaded once the LPG’d version is brought in. The resonance, particularly on QPAS, got a smidge out of hand, but nothing ear screaming or offensive.

René Y channel > Spectraphon A (stereo outputs) > QMMG Ch 3 & 4 (LPF) > X-Pan (Aux)
This is the slower, lower voice that was brought in last. Spectraphon’s A side Focus and Slide were modulated by Wogglebug. Once bright in, this voice was only level controlled by the cutoff of the filter in QMMG. I slowly brought up the envelope amount in Maths to open it further and further.

X-Pan (stereo outputs) > Mimeophon > Output

Maths is doing a lot of work, modulating the filter cutoff of both Both QPAS and QMMG, Radiate on QPAS, controlling the envelope level to the QMMG in LPG mode, as well as the crossfading of the continuous playing sequence and the pinged one. I need to find a better way to activate the crossfader. Since I was using a copy of a Maths Unity output in both of X-Pan’s Crossfade CV inputs, I couldn’t just attenuate it to 0v then introduce the crossfading by turning a knob. So I inserted the cables when I was ready to introduce the voice. You can hear that little fumble as that voice is brought in.